Speed problems with Flick Area
-
@kl3m3n
Good morning !
Bizarre question: I notice that if I load the widgets at 9600 baud, the "Flick Area" works very well, but if I'm at 19200 baud, it no longer works at all! amazing no....
greetings bernard -
@kl3m3n
Well I think I found the origin of the problem: on page 2 of my app. there are 2 identical graphs with the same parameters. When switching from 9600 to 19200 baud, I also added "YASC:1" for the 2 graphs (SWEEP). This command obviously does not work for this type (SWEEP) which causes the non-display on page 2 (without message). So I first thought it was a speed issue! sorry to have disturbed you.
Have a nice weekend Bernard -
@Bernard Hi Bernard!
Nice that you've solved the issue!
It would be very strange indeed if baud rate would affect the widgets responsiveness!
@Bernard said in Speed problems with Flick Area:
When switching from 9600 to 19200 baud, I also added "YASC:1" for the 2 graphs (SWEEP).
This is strange, sweep chart should support YASC parameter!
I will check this.Regards,
kl3m3n