<![CDATA[Speed problems with Flick Area]]>@kl3m3n
Good morning !
Bizarre question: I notice that if I load the widgets at 9600 baud, the "Flick Area" works very well, but if I'm at 19200 baud, it no longer works at all! amazing no....
greetings bernard

]]>https://forum.gui-o.com/topic/123/speed-problems-with-flick-areaRSS for NodeSat, 11 Apr 2026 05:56:56 GMTThu, 09 Mar 2023 23:28:29 GMT60<![CDATA[Reply to Speed problems with Flick Area on Fri, 10 Mar 2023 15:10:31 GMT]]>@Bernard Hi Bernard!

Nice that you've solved the issue!

It would be very strange indeed if baud rate would affect the widgets responsiveness!

@Bernard said in Speed problems with Flick Area:

When switching from 9600 to 19200 baud, I also added "YASC:1" for the 2 graphs (SWEEP).

This is strange, sweep chart should support YASC parameter!
I will check this.

Regards,
kl3m3n

]]>https://forum.gui-o.com/post/513https://forum.gui-o.com/post/513Fri, 10 Mar 2023 15:10:31 GMT<![CDATA[Reply to Speed problems with Flick Area on Fri, 10 Mar 2023 14:52:15 GMT]]>@kl3m3n
Well I think I found the origin of the problem: on page 2 of my app. there are 2 identical graphs with the same parameters. When switching from 9600 to 19200 baud, I also added "YASC:1" for the 2 graphs (SWEEP). This command obviously does not work for this type (SWEEP) which causes the non-display on page 2 (without message). So I first thought it was a speed issue! sorry to have disturbed you.
Have a nice weekend Bernard

]]>https://forum.gui-o.com/post/512https://forum.gui-o.com/post/512Fri, 10 Mar 2023 14:52:15 GMT